Few projects in life are as satisfying as restoring an older home to its original glory. But if your restoration involves the removal of old linoleum, the project quickly becomes extremely challenging. Taking up old linoleum and removing the adhesive is a huge job, but there are steps you can take to make it a little easier. The age of the linoleum and the type of adhesive can certainly make your job more difficult. Some people simply lay the new floor over the old linoleum, while others dig in with tools and plenty of elbow grease to get the job done.
To start with, it’s unlikely that you’ll be able to just remove the linoleum and adhesive all at once. What’s under the linoleum can be part of the problem, especially if it’s wood. Concrete floors can withstand a lot more in the way of rough treatment, including the type of scraper you use. Most people will use paint scrapers, although scrapers with a razor blade are usually more efficient. Be ready to break some blades it if the adhesive is hard, and you’re working on concrete.
If you try to remove everything at once, you’re in for an ever bigger and messier job. Try cutting the linoleum into sections or strips. Then, peel the smaller pieces away. Using this method, you should be able to remove most of the surface layer of linoleum along with a good portion of the backing. It’s also easier to get at the underlying adhesive when you use this method.
When the top layer is removed and you’re down to bits of adhesive, it’s time to get scraping. There are a few options to clean away the old glue. According to consumer reviews, Krud Kutter and other chemical solvents can make the job easier. If you decide to use any of these products, make sure that you read the instructions carefully. Be sure to wear gloves and a ventilation mask. Work one small area at a time before moving on to the next.
Boiling water can be used to soften the underlying adhesive. Try pouring very hot or boiling water directly on the remaining backing and adhesive, section by section. Give the hot water a few moments to sink in, and then scrape the softened glue. You can also fold an old towel over the adhesive and pour the hot water onto the towel. Let it set, remove the towel and scrape.
Heat can be another successful method of removing linoleum adhesive. Find an inconspicuous area behind a door or in a closet. Heat the adhesive with a hair dryer and scrape it using a putty knife or other style of straight blade scraper. If you’re uncovering a hardwood floor, be sure to push the scraper in the direction of the wood grain. Keep a pan or container nearby to dispose of the adhesive scrapings. Make sure that the container will not melt or ignite if it comes into contact with hot materials.
You may wish to move up to using a heat gun after you become comfortable with this process. If so, be careful not to overheat the wood and char it. You should also know that using this technique may allow some of the softened mastic to flow into the joints between the floorboards. Keeping the heated area small, constantly moving the heat source and scraping as quickly as possible will all help improve the outcome.
Bear in mind that this trick will never remove all of the old adhesive. Trying to scrape up all the old adhesive is likely to damage the wood. Scrape up the amount that will come up readily, sweep and vacuum, and consider your next step. In some cases a gentle sanding may be best. In other cases you may be able to scrub enough of the residue off with rags dampened with turpentine, mineral spirits or some similar solvent to get the floor ready to refinish. If you were going to apply a new covering that required new mastic, seal the wood and go ahead.
0 Responses to “Linoleum Removal is Hard but Doable”